Jump to content

ERTING


hazedunks

Recommended Posts

^ i swear whats your problem if you dont care then why come into the topic and comment some d*ckhead antics. You try go on like some e-thug for no reason to be honest. Need to llow this im better then everyone so i can just come into any topic and say/cuss whoever. need to come of your high horse to be honest.

Link to comment
Share on other sites

tbh evry community needs its fringe members who specialize in bizarre obsessions,be it this guy with haircuts or ybape with waste talksit is how u achieve equilibrium,by balancing extremities,not by enforcing uniformityimagine if suddenly there is a hairstyle crisis,evry1 will run to this guy for helpppl shud feel free to be themselves and pursue there interests to a reasonable extent eotdyoung man,all the best with yr peculiar fascinationthe world is yours

Link to comment
Share on other sites

You take your clippers

dsci0225tj2.jpg
Take off the part shown as shown
dsci0229ua3.jpg
The result is
dsci0231bx5.jpg
The two sets of teeth come away as shown
dsci0237sa0.jpg
In the next picture the brownish lookin T shaped component is the part you need to be looking at...The smaller set of teeth slide back & forth along the top edge of the 'brown T shaped component' shown as exhibit A...Raise the height of this edge by losening the screws that hold it in place just slightly (exhibit B ), push it up a FRACTION with your fingernail and tighten it back. By doing this you effectively increase the sharpness of the clippers. Do the opposite to make the clippers less sharp.***Anyhow you adjust the smaller set of teeth above the the larger ones... The clippers will bite your skin!***
dsci0243copyzg9.jpg
To make sure its even you can put the teeth on a flat surface and push the 'brownish T shaped component' down. Hold it in place. And tighten it up.Like so...
dsci0252tx8.jpg
When you put them back together make sure the motor that vibrates the blades goes back in the hole...
dsci0253yv6.jpg
Screw your sh*t back up
dsci0258lw7.jpg
Test the sharpness of the cut on the inside of your forearm, if its too sharp for your skin there its too sharp to touch your face!!!
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...